Powering On, Initial Steps; Plug In The Mains Cable And Turn On The Device; Initial Steps - Fronius Virtual Welding 2.0 Operating Instructions Manual

Powering on, initial steps

Plug in the mains
cable and turn
on the device
Danger from electrical current.
This may result in serious injuries or death.
▶
▶
Risk of poor acclimatization of components by connecting the device to the
mains too early.
This can result in damage to the device
▶

Initial steps

1
2
3
4
5
6
The Virtual Welding system is now fully functional.
44
WARNING!
Only use the supplied mains cable to connect to the mains.
Only connect the mains cable to a properly grounded socket.
CAUTION!
Do not connect the device to the mains and switch it on until 4 hours after
the setup has been completed.
(2)
(1)
Confirm the license agreement displayed
Sett the time and date
- Follow the instructions on the touch screen
Perform sensor registration
- Follow the instructions on the touch screen
- Create at least one NFC key for administrators
Define the design / camera position:
- Follow the instructions on the touch screen
Perform room calibration:
- See section Room calibration
Performing system calibration:
- See section Performing system calibration
Plug the mains cable into the con-
1
nection (1)
Plug the mains cable into a socket
2
Switch the power switch (2) to the -
3
I- position
from page 89
from page 91