Closing The Housing - Fronius Trans Pocket 1500 Service Instructions Manual

Fitting the FPA15
board
(continued)
Fig.18
Fig.19
Closing the
housing
Fig.20
(34)
Fig.21
(68) (55) (72) (73)
(5) (40) (41)
(21) (37)
(36)
(35)
- Fasten the X3 cable (blue) (72) and
the by-pass capacitors (73) onto the
copper bracket (55), using the 5x12 -
TX20 screw (68)
- Tighten the 5x12 - TX20 screw (68)
with a torque of 2 Nm
- Plug the 10-pole Molex plug (41) onto
(42)
board LCA15
- Plug the 2-pole Molex plug (40) onto
board LCA15
- Arrange the ribbon cable (42) above
the cable harness, as shown in Fig.19
- Plug the ribbon cable (42) to board
FPA15 (5)
- Insert the board insulator (37)
- Insert the housing stiffening element
(21)
- Plug the "housing earth conductor"
(36) onto the housing box, in the
correct position
- Replace the housing box
- Screw the 5x25-TX20 screw (35) back
onto the rear of the housing
- Screw the 5x25-TX20 screw (34) back
onto the front of the housing
- Fit the carrying strap back on again
105