Mounting The Shunt And Connecting The Leads - Fronius Trans Pocket 1500 Service Instructions Manual

Mounting the
shunt and
connecting the
leads
Fig.16
- Fasten the shunt (54) and the two leads "Socket X3" (blue) (64) to the copper bracket
- Insert the welding-voltage measuring lead (red) (57) into the 10-pole Molex plug (41)
Fig.17
(57) (41)
(55)
- tighten the M5x12-TX20 screw (56) with a torque of 2 Nm
1X10/Pin3
(5) (33) (40) (41)
- Plug the 10-pole Molex plug (41) onto
(42)
board LCA15/1X10
- Fix the cable harness for Molex plugs
(40) and (41), using a cable binder (33)
- Arrange the ribbon cable (42) above
the cable harness, as shown in Fig.15
- Plug the ribbon cable (42) to board
FPA15 (5)
60
Note! Before plugging in the
ribbon cable (42), pass it across
the cable harness for Molex
plugs (40) and (41).
(54)
(64)
(56)
(55)
(64)