History; Measuring And Testing Equipment, Tools; General Remarks - Fronius Trans Pocket 1500 Service Instructions Manual

History

Modification No modifications have yet been made to the TP 1500 series.

Measuring and testing equipment, tools

General remarks

Measuring and - Oscilloscope
test equipment
- Multimeter with diode-testing function
- Shunt (measuring range: up to 180 A)
- Power resistor (160 mOhm / P > 3.14 kW)
- Power resistor (4 Ohm / P > 400 W)
- Test unit for PE conductor test (cross-sectional area of PE conductor: 1.5 mm²)
- Test unit for insulation test
- Recommended: Measuring circuit for testing the open-circuit voltage (see the
Tools and Designation
appliances (1) Manual torque screwdriver 1 to 6 Nm
(2) Bit insert TX 20, for torque screwdriver
(3) Bit insert hexagon-socket, width-across 3, for torque screwdriver
(4) Molex extractor tool
(5) Grinding paper (grain P 500 or finer)
(6) Contact spray
(7) Socket spanner holder with 1/4'' external hexagonal-socket drive and 1/4'' external
(8) Socket spanner insert - width-across 7 - with 1/4 '' internal square-socket drive
Fig.1Tools and appliances
Note! Observe the calibration intervals specified by your QM System for the
measuring and testing equipment and tools that are used.
section headed "Measuring, inspection and adjustment jobs")
square-socket drive, to fit torque screwdriver
(1)
(4)
(6)
(5)
31
(2)
(3)
(7)
(8)