Fronius Trans Pocket 1500 Service Instructions Manual page 218

Fitting the seal
for the remote-
control unit
connection
socket
(7)
Fig.13
Fitting the FPA15
board
- TP 1500 RC / 1500 TIG: Apply a thin layer of lubricant to the seal of the remote-
- TP 1500 RC / 1500 TIG: Apply gentle pressure to the seal of the remote-control
- Snap the FPA15 board (5) (Fig.9) onto the rear alignment pin first
Fig.14
Fig.15
Fig.16
Note! Before fixing the FPA15 board (5) on the alignment pins, do the
following:
control socket (7) (Fig.13)
socket (7), to prevent it being forced out when you press on the FPA15 board
(Fig.14)
(69) (70)
Fig.17
- Carefully insert the seal (7) for the
remote-control unit connection socket
into the front of the housing
- Carefully press the FPA15 board until
all the alignment pins have snapped
into place
(7)
- Swing the copper bracket (55) back
into its original position
(55)
- TP 1500 TIG: Tighten the hexagon nut
(69) (width-across=13) for the screw-
fixing of the
- TP 1500 / 1500 RC: In the
tighten the M5x12 (TX20) screw (70)
with a torque of 2 Nm.
104
socket
socket,