Installation Instructions: Mains Switch And Mains Cable; Safety; Scope Of Supply; Tools Needed - Fronius Trans Pocket 1500 Service Instructions Manual

Installation instructions: Mains switch and mains cable

Safety

General remarks These installation instructions apply to both the mains switch and the mains cable. If the
mains switch is to be dismounted, but not the mains cable, the following sections may
be omitted:
-
-
If the mains cable is to be dismounted, but not the mains switch, the following sections
may be omitted:
-
-

Scope of supply

The assembly "Mains cable" (43,0004,2133) comprises the following component:
Item
(11)
The assembly "Mains switch" (43,0002,0295) comprises the following component:
Item
(12)

Tools needed

Designation
- Manual torque screwdriver (1 to 6 Nm, 42,0411,0013)
- Bit insert TX 20, for torque screwdriver
Opening the
(34)
housing
Fig.1
Warning! Work performed incorrectly can cause serious injury and damage.
This modification may only be performed by suitably trained and skilled
electricians! Before opening up the machine, shift the mains switch to the "0"
position and unplug the machine from the mains!
Note! Follow the safety rules given in the Operating Instructions, especially the
section headed "Safety inspection".
"Removing the mains cable"
"Mounting the mains cable"
"Removing the mains switch"
"Fitting the mains switch"
Designation
Mains cable ........................................................................................................ 1
Designation
Mains switch ...................................................................................................... 1
(36)
(35)
- Take off the carrying strap
- Undo the 5x25-TX20 screw (34) on the
front of the housing
- Undo the 5x25-TX20 screw (35) on the
rear of the housing
- Carefully lift the housing box and
disconnect the "housing earth
conductor" (36)
92
N° of items
N° of items