Removing The Mains Cable - Fronius Trans Pocket 1500 Service Instructions Manual

Removing the
mains cable
Fig.5
Fig.6
Fig.7
Fig.8
(84) (85) (86)
(49) (87)
(34)
(87)
94
- On the mains leads L - brown (84) and
N - blue (85), detach the insulating
sleeves (86) from the flat-pin plugs
- Insert a small screwdriver on the
step-shaped side of an insulating
sleeve and prise off the sleeve
- On the heat sink, disconnect the
mains-cable earthing conductor (87)
and detach it from the air-guide film
(49)
- At the rear of the machine, loosen the
M5x25 - TX20 screws (34) for the
mains-cable strain relief device
- Push the mains cable a short way into
(88)
the housing
- Unwind the mains-cable earthing
conductor (87) from the ferrite core
(88)
- Pull the mains cable out of the housing