Installation Instructions: Potentiometer, Connection Socket + Seal For Remote Control Unit; Safety; Scope Of Supply; Tools Needed - Fronius Trans Pocket 1500 Service Instructions Manual

Installation instructions: Potentiometer, connection
socket + seal for remote control unit

Safety

General remarks These installation instructions describe the entire procedure for removing and fitting the
FPA15 board, complete with potentiometer, connection socket for the remote control
unit, and seal for the connection socket.
If you intend to replace either the potentiometer, the remote-control unit connection
socket or the seal for the remote-control unit connection socket separately, you must
read and observe the sections headed "Removing the FPA15 board" and "Fitting the
FPA15 board".

Scope of supply

The assembly "Potentiometer" (41,0001,0632) comprises the following component:
Item
(29)
The assembly "Remote-control unit connection socket" (43,0003,0756) comprises the
following component:
Item
(30)
The assembly "Seal for remote-control unit connection socket" (42,0405,0302)
comprises the following component:
Item
(7)
Designation

Tools needed

- Manual torque screwdriver (1 to 6 Nm, 42,0411,0013)
- Bit insert TX 20, for torque screwdriver
Additional
- Socket spanner holder with 1/4'' external hexagonal-socket drive and 1/4'' external
needed tools
- Socket spanner insert - width-across 7 - with 1/4'' internal square-socket drive
Warning! Work performed incorrectly can cause serious injury and damage.
This modification may only be performed by suitably trained and skilled
electricians! Before opening up the machine, shift the mains switch to the "0"
position and unplug the machine from the mains!
Note! Follow the safety rules given in the Operating Instructions, especially the
section headed "Safety inspection".
Designation
Potentiometer ..................................................................................................... 1
Designation
Remote-control unit connection socket .............................................................. 1
Seal for remote-control unit connection socket .................................................. 1
square-socket drive, to fit torque screwdriver
100
N° of items
N° of items
N° of items