Powering On, Initial Steps; Plug In The Mains Cable And Turn On The Device; Initial Steps - Fronius Virtual Welding 2.0 Operating Instructions Manual

Powering on, initial steps

Plug in the mains
cable and turn on
the device
Danger from electrical current.
This may result in serious injuries or death.
► Only use the supplied mains cable to connect to the mains.
► Only connect the mains cable to a properly grounded socket.
Risk of poor acclimatization of components by connecting the device to the mains
too early.
This can result in damage to the device
► Do not connect the device to the mains and switch it on until 4 hours after the setup

Initial steps

1
2
3
4
5
6
The Virtual Welding system is now fully functional.
44
WARNING!
CAUTION!
has been completed.
(2)
(1)
Confirm the license agreement displayed
Sett the time and date
Follow the instructions on the touch screen
-
Perform sensor registration
Follow the instructions on the touch screen
-
Create at least one NFC key for administrators
-
Define the design / camera position:
Follow the instructions on the touch screen
-
Perform room calibration:
See section Room calibration
-
Perform component calibration:
See section Component calibration
-
Plug the mains cable into the connec-
1
tion (1)
Plug the mains cable into a socket
2
Switch the power switch (2) to the -I-
3
position
from page 89
from page 91