Installation Instructions: Lcg15 Board And Secondary Diode; Safety - Fronius Trans Pocket 1500 Service Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Installation instructions: LCG15 board and
secondary diode

Safety

Scope of supply
The assembly "LCG 15 board" (4,070,778,Z) comprises the following component:
Item
(3)
The assembly "Secondary diode" (4,100,319) comprises the following components:
Item
(4)
(31)
(50)
(51)
(52)
(53)
Tools needed
Designation
- Manual torque screwdriver (1 to 6 Nm, 42,0411,0013)
- Bit insert TX 20, for torque screwdriver
- Bit insert hexagon-socket, width-across 3, for torque screwdriver
- Molex extractor tool (42,0410,0290)
- Grinding paper (grain P 500 or finer)
- Contact spray
Opening the
(34)
housing
Fig.1
Warning! Work performed incorrectly can cause serious injury and damage.
This modification may only be performed by suitably trained and skilled
electricians! Before opening up the machine, shift the mains switch to the "0"
position and unplug the machine from the mains!
Note! Follow the safety rules given in the Operating Instructions, especially the
section headed "Safety inspection".
Designation
LCG15 board ..................................................................................................... 1
Designation
Secondary diode ................................................................................................ 1
Screws M4x14-TX20 .......................................................................................... 2
Diode holder ....................................................................................................... 1
Spacers .............................................................................................................. 4
Screws M4x20-TX20 .......................................................................................... 4
Cup springs ........................................................................................................ 2
(36)
(35)
- Take off the carrying strap
- Undo the 5x25-TX20 screw (34) on the
front of the housing
- Undo the 5x25-TX20 screw (35) on the
rear of the housing
- Carefully lift the housing box and
disconnect the "housing earth
conductor" (36)
55
N° of items
N° of items

Advertisement

Chapters

Table of Contents
loading

Table of Contents