Rebooting The Device Or A Module - H3C SR6602-I Installation Manual

Rebooting the device or a module

CAUTION:
• If the main system software image file does not exist, do not use the
the device. Specify the main system software image file first, and then reboot the device.
• The precision of the rebooting timer is 1 minute. 1 minute before the rebooting time, the device
prompts "REBOOT IN ONE MINUTE" and reboots in one minute.
• If you are performing file operations when the device is to be rebooted, the system does not
execute the
To reboot the device or a module, use one of the following methods:
•
Reboot the device at the CLI.
Reboot the device immediately by using the

Schedule a reboot to occur at a specific time or date or after a delay by using the

schedule reboot
•
Power off and then power on the device. This method cuts off the power of the device forcibly,
which might cause data loss and hardware damage. It is the least-preferred method.
To reboot a module or the device immediately:
Task
Reboot a module or the device
immediately.
To schedule a reboot:
Task
Schedule a reboot.
command for security.
reboot
command.
Command
reboot [ slot
slot-number ]
Command
•
•
reboot
Schedule a reboot to occur at
a specific time or date:
schedule reboot at
hh:mm [ date ]
Schedule a reboot to occur
after a delay:
schedule reboot
delay { hh:mm | mm }
11-9
command to reboot
reboot
command.
Remarks
If you do not specify the
slot-number
option, the
command reboots the device.
Available in user view.
Remarks
Use either approach.
By default, no reboot date or time
or reboot delay time is specified.
Available in user view.
slot