Troubleshooting An Mim; 1Fe/2Fe/4Fe Module; Introduction; Appearance - H3C SecPath V100-E Installation Manual

Troubleshooting an MIM

You can read the LEDs on the MIM panel to check for the MIM installation.
If the MIM on the V100-E does not operate normally, check that:
Correct interface cables are used.
The interfaces are working well by reading the interface LEDs.
The configurations on the MIM are validated by executing the display command.

1FE/2FE/4FE Module

Introduction

1-/2-/4-port 10Base-T/100Base-TX Fast Ethernet interface module (1FE/2FE/4FE) provides the
communications between the V100-E and a LAN.
The 1FE provides one 10/100 Mbps Ethernet interface with the RJ-45 connector, while the 2FE and
4FE can provide two and four. All of them support:
The transmission distance of 100 meters (328 ft) over the category-5 twisted-pair cable.
The operating rates of 100 Mbps and 10 Mbps, with autosensing.
Full duplex (commonly used) and half duplex.

Appearance

Appearance of the 1FE module
Figure 8-3 shows the 1FE module.
Figure 8-3 1FE module
Appearance of the 2FE module
Figure 8-4 shows the 2FE module.
8-3