H3C SR6602-I Installation Manual page 38

Figure5-3 Removing the filler panel
4. (Optional.) If the FIP module has a protective cover at the connector end, remove the cover and
keep it secure.
Figure5-4 Removing the protective cover
5. Press the red latch to disengage the ejector lever from the FIP module.
6. Holding the ejector lever by one hand and supporting the FIP module by the other, push the FIP
module slowly into the slot along the guide rails.
7. Close the ejector lever until the FIP module is securely seated in the slot.
5-3