H3C SR6602-I Installation Manual page 32

4. Remove the module blank from the riser module. Use a Phillips screwdriver to loosen the screw
on the module blank and then pull the module blank slowly out of the riser module.
Figure4-11 Removing the module blank from the riser module
5. Install the GPU in the riser module and connect the GPU power cord:
a. Connect the end marked "Riser" of the GPU power cord to the riser module and then
connect the other end of the power cord to the GPU module.
b. Insert the GPU into PCIe slot along the guide rails and fasten the screws to secure the GPU
to the riser module.
c. Use the cable ties provided with the riser module to secure the GPU power cord to the cable
tie holders on the side panel.
Figure4-12 Installing the GPU in the riser module
4-10