Replacing A Mic-X Interface Card - H3C SR6602-I Installation Manual

Figure10-5 Removing a FIP module

Replacing a MIC-X interface card

CAUTION:
You cannot install but can remove a MIC-X interface card when the device is operating.
To replace a MIC-X interface card:
1. Verify that the FIP module is operating correctly.
The remove LED on the FIP module is steady green when the FIP module is operating correctly.
You can also use the
operating status.
2. Wear an ESD wrist strap. Make sure the wrist strap makes good skin contact and is reliably
grounded.
3. Use a Phillips screwdriver to loosen the captive screws on the module.
4. Open the two ejector levers of the interface card simultaneously.
5. Pull the interface card slowly out of the slot along the guide rails.
6. Place the removed interface card on an antistatic mat.
7. Install a new MIC-X interface card.
CAUTION:
To install a new MIC-X interface card, first remove the FIP module from the device. For the
installation procedure, see
If you are not to install a new MIC-X interface card, install a filler panel in the slot.
display device verbose
"Installing MIC-X interface
10-4
command to view the FIP module
cards."