Replacing A Gpu - H3C SR6602-I Installation Manual

Replacing a GPU

1. Power off the device.
2. Remove the access panel. For more information, see
3. Use a Phillips screwdriver to loosen the screws that secure the riser module to the chassis. For
more information, see
4. Remove the riser module. For more information, see
5. Place the removed riser module on an antistatic mat.
6. Remove the GPU from the riser module.
a. Use a Phillips screwdriver to remove the two screws that secure the GPU to the riser
module.
b. Remove the cable ties from the riser module. Avoid damaging the GPU power cords during
the cable tie removal procedure.
c. Pull the GPU slowly out of the PCIe slot and remove the power cords from the GPU.
Figure10-13 Removing the GPU
"Replacing a storage controller."
10-9
"Replacing a storage
"Replacing a storage controller."
controller."