H3C SR6602-I Installation Manual page 56

5. Place the removed riser module on an antistatic mat.
6. Use a Phillips screwdriver to remove the screws that secure the storage controller to the riser
module. Then remove the storage controller from the PCIe slot of the riser module.
Figure10-11 Removing the storage controller from the riser module
7. Place the removed storage controller on an antistatic mat.
8. Install a new storage controller in the PCIe slot on the riser module. For the installation
procedure, see "Installing a storage
If you are not to install a new storage controller, connect the drive backplane cable. Then install
a module blank in the PCIe slot on the riser module and reinstall the access panel.
Figure10-12 Connecting the drive backplane cable
controller."
10-8