Load Sense/Dual Load Zone Module Error - Skyjack SJ82 T Service Manual

Telescopic booms
Hide thumbs Also See for SJ82 T:
Table of Contents

Advertisement

Load Sensing System - CE

4.4-3 Load Sense/Dual Load Zone Module Error

When a fault is detected, the module outputs will have limited operation depending on the fault type:
For ANY and all faults:
Load zone border light is turned on
Low capacity lamp and high capacity lamp will flash alternately
Overload lamp will flash
The Red diagnostic LED on The module will be illuminated (no flashing)
If a short circuit is detected on wire 120, 82, or 119:
The output that is shorted will be disabled (open, high Z to ground)
120 shorted: high capacity light on solid, border light on solid, overload light flashes
82 shorted: capacity lights flash alternately, border light on solid, overload light off
119 shorted: capacity lights flash alternately, border light off, overload light flashes
If a short circuit is detected on any safety contact (wire 162B, 13A, or 39A):
All safety contacts will be disabled (opened)
Stowed Position: all functions are available
Off limits(boom extended and/or boom above 10°): No functions and overload alarm pulses with overload
light.
If the measured load falls below the tare (no load/empty platform) calibration point by 2.0mA, for 1.5
seconds:
13A is disabled (open) – Down Function is disabled. Will self-clear when the measured load returns to
normal.
Module Amber and Green diagnostic LEDs flash together
If a discrepancy is detected between the load cell analog inputs (delta > 2mA for 2.0 seconds):
Wire 162B, 13A, and 39A are disabled (opened) - – Stowed Position: all functions are available: lower and
retract functions may not be operable. Off limits: (boom extended and/or boom above 10⁰): No functions
and overload alarm pulses with overload light.
Module Amber and Green diagnostic LEDs on the module flash alternately
To reset the module hold the actuator button down for 5 seconds, or shut the MEWP platform power off
using the ignition switch or e-stop..
SJ82 T, SJ86 T
Section 4 – Troubleshooting Information
229040ABA
159

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sj86 t

Table of Contents