Table of Contents
Advertisement
Section 5 – Procedures
Standstill Regeneration Stages
Standstill
Lamps
3
4
Flashes slowly
Flashes slowly
Flashes quickly
Do the Standstill Regeneration
1. Move the MEWP to an open, well-ventilated
area, away from any flammable material. Park it
on a firm level surface, and fully stow the MEWP .
2. While the engine runs, turn the off/base/platform
switch
on the base controls to the base
7
position.
3. Move the standstill switch
controls to the right to start the standstill
regeneration. The base functions will not operate
while the standstill switch is turned on.
4. On the engine display module
and hold the middle button
regeneration symbol) for 7 seconds.
WARNING
Do not touch hot engine components. Serious
injury can occur if you touch hot surfaces.
5. The engine display module changes to the
Regeneration Ongoing symbol
lights illuminate continuously, and the engine
speed can change.
6. Standstill regeneration takes approximately
45 minutes. During this time you must not use
the MEWP .
229040ABA
242
Engine
Audible
Lamp
Alarm
5
Pulsates
Off
slowly
Pulsates
On
slowly
Pulsates
Flashes
quickly
on the base
8
press
2
(below the
9
, the standstill
10
Engine
Torque
6
Do the standstill operation at the next available
100%
opportunity, within 3 to 4 hours.
75%
Do the standstill operation immediately.
a. The standstill operation is no longer possible with
on-machine controls.
Contact an authorized repair facility.
40%
b. Failure to do the standstill has caused diesel
particulate filter failure, and regeneration is no
longer possible. Contact an authorized repair facility
to replace the filter.
IMPORTANT
Complete the standstill regeneration fully. If
you interrupt the process, the standstill request
continues.
7. When the standstill regeneration is complete,
the Regeneration Ongoing symbol changes to
Regeneration Complete
go off, and the engine speed goes back to
3
4
normal.
8. Move the standstill switch to the left. You can use
the MEWP normally.
IMPORTANT
Only use the standstill regeneration override
switch
on the front of the platform control box
12
when absolutely necessary to move the MEWP to
park it in a safe location when the derated engine
torque/rpm prevents sufficient torque to drive the
MEWP .
It temporarily (for approximately 30 minutes)
restores full engine power and speed.
Use of the derate override switch can cause diesel
particulate filter failure.
Deutz Diesel Engines
Action Required
, the standstill lights
11
SJ82 T, SJ86 T
Advertisement
Table of Contents
