Turret Rotate Relief Valve Adjustment; Platform Level Relief Valve Adjustment - Skyjack SJ82 T Service Manual

Telescopic booms
Hide thumbs Also See for SJ82 T:
Table of Contents

Advertisement

Section 5 – Procedures
5.8-5 Turret Rotate Relief Valve
Adjustment
1. Locate the GP2 port
2. Connect a pressure gauge (5000 psi) to the GP2
port.
R V
G P
3
2
S V
3
D S
V 3
1
Main Manifold
3. Start the engine from the base control console
and let it run for 2-5 minutes.
4. Raise the main boom to ensure the basket will
not contact the ground.
5. Engage the turret transport lock.
6. Attempt to rotate the turret. The pressure should
be 1250 psi. Follow the next steps for adjusting
the pressure, if needed.
7. Locate the turret rotate relief valve RV2
8. Loosen the lock nut on the turret rotate relief
valve RV2. Turn the adjusting stem clockwise to
increase the pressure and counterclockwise to
decrease the pressure.
9. Tighten the lock nut on the turret rotate relief
valve RV2 once 1250 psi is observed on the
gauge. You must activate the turret rotate to
obtain a pressure reading on the gauge.
10. Disengage the turret transport lock.
229040ABA
248
on the main manifold.
1
2
D S
V 1
D S
V 2
4
C V
5
C V
.
2
5.8-6 Platform Level Relief Valve
Adjustment
1. Locate the GP2 port
2. Connect a pressure gauge (5000 psi) to the GP2
port.
R V
G P
3
2
S V
3
2
D S
V 3
1
Main Manifold
3. Start the engine from the base control console
and let it run for 2-5 minutes.
4. Raise the main boom to ensure the basket will
not contact the ground.
5. Fully raise or lower the platform level and check
the reading on the gauge. The pressure should
be 3000 psi. Follow the next steps for adjusting
the pressure, if needed.
6. Locate the platform leveling relief valve RV3
7. Loosen the lock nut on the platform level relief
valve RV3. Turn the adjusting stem clockwise to
increase the pressure and counterclockwise to
decrease the pressure.
8. Tighten the lock nut on the platform level relief
valve RV3 once 3000 psi is observed on the
gauge. You must fully raise or lower the platform
level to activate a pressure reading on the
gauge.
Manifolds and Hydraulic Pumps
on the main manifold.
1
D S
V 1
D S
V 2
4
C V
5
C V
SJ82 T, SJ86 T
.
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sj86 t

Table of Contents