Table of Contents
Advertisement
Section 4 – Troubleshooting Information
16. Loose or broken wire #57C from X23 engine plug
to start solenoid 57CCR.
17. Loose or broken starter cable #03 from
disconnect switch S1 to start solenoid 57CCR.
18. Defective start solenoid 57CCR.
19. Defective starter motor.
With the following conditions:
Equipped with Elevate/Trackunit Telematics Ready
▪
NOTE
If the unit is equipped with an Access keypad, a passcode is required from the machine owner.
1. Loose or broken B+ wire from battery + to
telematics pin 3.
2. Loose or broken B- wire 00 from battery - to
telematics pin 4.
3. Loose or broken wire 07 from S3 base
Emergency stop switch to 57DCR pin 86.
4. Loose or broken wire 57A from S5 ignition switch
to 57DCR pin 30.
5. If telematics device is not installed: loose, broken
or missing Jumper JMPR1 from 57DCR pin 85 to
ground 00.
6. Loose or broken wire 57D from telematics pin 9
to 57DCR pin 85.
7. Missing output from telematics pin 9.
8. Defective relay 57DCR.
9. Loose or broken wire 57B from 57DCR pin 87 to
engine starter contactor coil.
10. Defective telematics module.
229040ABA
116
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check solenoid. Replace if defective.
Check starter motor. Replace if defective.
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check continuity. Replace if defective or missing.
Check continuity. Replace if defective.
Check for ground on pin 9. If no ground, contact
the machine owner.
Check relay. Replace if defective.
Check continuity. Replace if defective.
Check telematics assembly; repair or replace as
required.
Electrical System
SJ82 T, SJ86 T
Advertisement
Table of Contents
