Skyjack SJ82 T Service Manual page 112

Electrical System
5. Loose or broken wire #K01 from ECU fuse
connector P6 pin B to 94 pin ECU connector 3
places pins 1, 3, and 5.
6. Loose or broken ground wire #00 from battery
B- to 94 pin ECU connector 3 places pins 2, 4,
and 6.
NOTE
For other engine related problems, consult engine manufacturer's manual.
With the following conditions:
Deutz Diesel D2011
▪
1. Loose or broken wire #57A at relay 57ACR (2
places).
2. Loose or broken wire #57A from relay 57ACR to
relay 57BCR.
3. Loose or broken wire #00A from X23 engine
connector pin #11 to relay 57ACR.
4. Loose or broken wire #00A from X23 engine
connector pin #11 to engine oil pressure switch.
5. Defective relay 57ACR.
6. Loose or broken wire #09 from base terminal
block to relay 09CR.
7. Loose or broken wire #03A from circuit breaker
CB3 to relay 09CR.
8. Tripped or defective circuit breaker CB3.
9. Loose or broken wire #3 from circuit breaker CB3
to turret harness plug pin #2.
10. Loose or broken wire #02 from relay 09CR to
base terminal block.
11. Defective relay 09CR.
12. Loose or broken wire #54A from relay 09CR to
base terminal block.
13. Loose or broken wire #54A from base terminal
block to relay 57BCR1.
14. Defective contacts in relay 57BCR1.
15. Loose or broken wire #57C from relay 57BCR1 to
X23 engine connector pin #4.
SJ82 T, SJ86 T
Section 4 – Troubleshooting Information
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check for connections at relay. Check for voltage
on relay (2 places).
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check relay. Replace if defective.
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Reset circuit breaker. Check continuity through
circuit breaker. Replace if defective.
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check relay. Replace if defective.
Check continuity. Replace if defective.
Check continuity. Replace if defective.
Check continuity between wires #54A and #57C
when cranking. If no continuity, replace relay.
Check continuity. Replace if defective.
229040ABA
115