Inspection Before Operating The Machine; Inspecting The Machine; Inspecting The Cleaning Area - SoftBank Whiz Operational Manual

Whiz Operational Manual

Inspection Before Operating the Machine

Before starting manual cleaning mode/autonomous cleaning mode, be sure to perform the following inspection.

Inspecting the Machine

n Check that the emergency stop button is not pressed.
n Check that the grounding chain on the bottom of the machine is in contact with the floor.
n Check that the secondary battery power button on the bottom of the machine is off (⇒see "Secondary Battery
Power Button").
n Check the HEPA filters, and replace with new HEPA filters if especially dirty (⇒see "HEPA Filters").
n Check the hopper tray is empty (⇒see "Hopper Tray").
n Check that there is no dust or dirt on the 2D/3D camera (sensor), LIDAR sensor, or Cliff sensors and wipe as
required (⇒see "Sensors").
Use the micro-fiber cloth to wipe away any dust or dirt.
* Do not wet any of the sensors or the micro-fiber cloth mentioned above, with water.
Do not place any objects near the sensors.
n Check the brush for caught dust and hair, and remove as required (⇒see "Brush").
n Check that the brush is attached properly.
If the brush is damaged/broken, replace with a new brush.
n Check that the dustbin cover, filter cover, and battery door are closed firmly.

Inspecting the Cleaning Area

n Check that the cleaning area is an environment where cleaning is possible.
The machine is not water resistant. Use the machine in a dry location.
51