Pictorial Symbols - SoftBank Whiz Operational Manual

Pictorial Symbols

efer to the labels on each product (the machine, battery charger, battery).
R
Do not short-circuit.
Do not immerse in water or other
liquid.
n FCC Compliance Statement
The Whiz Vacuum and the Notification Pager comply with part 15 of the FCC rules.
Note with respect to the Whiz Vacuum:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
This equipment (FCC ID: 2AT19-A00000101A01) complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance requirements. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Note with respect to the Notification Pager:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This pager device (FCC ID: 2AT19-P00000401A01) is designed to meet the requirements for exposure to radio
waves established by the Federal Communications Commission (USA). These requirements set an SAR limit for
an occupational/controlled environment of 0.4 W/kg, as averaged over the whole body, and a peak spatial
average SAR of 8 W/kg, averaged over any 1 gram of tissue. The highest SAR value reported under this
standard during product certification for use when properly worn on the body is 0.06 W/kg. This device was
tested for typical body-worn operations with a separation of 10mm from the body. To maintain compliance with
FCC radio frequency exposure requirements, use accessories that maintain a 10mm separation distance
between the user's body and the back of the pager. The use of belt clips, holsters, and similar accessories that
contain metallic components in their assembly should be avoided, as use of such accessories might not comply
with FCC exposure requirements.
Do not disassemble.
13