SoftBank Whiz Operational Manual page 136

Terminology
Grounding chain
HEPA filters
H
HEPA filter covers
Home Location Code
Hopper tray
LED lights
L
Lift handles
Main power switch
M
Manual cleaning
Max power mode
Max power mode
button
Micro-fiber cloth
Normal mode
N
Notification pager
charger
Notification pager
Notification
Operator
O
Pager compartment
P
Chain for channeling the machine's electrical charge (static electricity) to the ground.
Before using the machine, check that the grounding chain is in contact with the floor.
High-performance exhaust filters located at the exhaust of the machine for removing
dirt and particles (⇒see "HEPA Filters").
Removable covers on the machine's exhaust (⇒see "HEPA Filters").
Code used for having the machine learn where cleaning start/end points are in
autonomous cleaning mode. One code can be used for the machine to learn six
routes (⇒see "Home Location Codes").
Tray for holding dirt collected by the brush. Discard any dirt in the tray after
every cleaning (⇒ see "Hopper Tray").
LED lights for indicating machine status, safety, and errors. LED lights are
located at positions from the front of the machine to its back, and light in different
colors and patterns (⇒see "LED Lights").
Used when lifting the machine from the floor. For your safety, work with two
people when lifting the machine.
Switch for turning on/off the machine. Press "I" to turn the machine on, and "O"
to turn the machine off (⇒see "Main Power Switch").
Use the handle for making the machine travel through and clean a cleaning area
manually (⇒ see "Manual Cleaning").
Mode with more vacuum power than normal mode. Cleaning in max power mode
is recommended for cleaning especially dirty locations (⇒see "Max Power Mode
Button").
Button for switching from normal mode to max power mode (⇒see "Max Power
Mode Button").
Cloth used during maintenance of the 2D/3D camera, LIDAR sensor, and cliff
sensor.
The usual mode for cleaning (⇒see "Max Power Mode Button").
Used for recharging the notification pager. Use a Micro USB cable to recharge
the notification pager (⇒see "Recharging the Notification Pager").
Receives alert messages when the machine encounters obstacles or if the
emergency stop button is pressed during an autonomous operation. When an
alert is received, it notifies the operator with sound and vibrations (⇒see
"Notification Pager").
To recharge the notification pager, use the special charger.
Low battery level and errors are reported as notifications. Notifications appear at
the upper left of the machine's touch display (⇒see "Touch Display").
The person who operates and manages the machine.
Used for attaching the notification pager on the machine.
131
Description