Removing And Fastening The Seat Cushion; Removing And Fastening The Back Support Pad - Otto Bock Invader 480S26 10000 K Instructions For Use Manual

9.4.1 Removing and fastening the seat cushion

The seat cushion can be removed for cleaning.
1) Remove the seat cushion from the seat pad (see fig. 33).
2) After cleaning (see Page 37): Place the seat cushion on the seat pad. The seat cushion is secured against
sliding by being pressed on to the hook-and-loop fastener.
33

9.4.2 Removing and fastening the back support pad

The backrest pad can be removed for cleaning.
1) Remove the seat cushion from the seat pad.
2) Pull the lower end of the backrest pad off the hook-and-loop fastener on the seat pad (see fig. 34).
3) Pull the back padding up and off (see fig. 35).
4) After cleaning (see Page 37): Put the back padding back onto the back upholstery. Position the seam of the
backrest padding exactly over the upper upholstery strap (see fig. 36, item 1).
5) Pull the backrest padding down and attach it to the hook-and-loop fastener on the back upholstery.
6) Attach the lower end of the backrest padding to the hook-and-loop fastener on the seat pad (see fig. 37).
INFORMATION: This prevents sliding and protects against draughts.
7) Fasten the seat cushion to the hook-and-loop fastener on the seat pad.
34
Invader 480S26=10000_K
35
Use
25