Rotating The Seating Unit; Adjusting The Tilt-Limiting Mechanism After Rotating The Seat; Adjusting The Back Angle - Otto Bock Kimba Neo Instructions For Use Manual

8
Mounting the seating unit
See the section "Assembly: Mounting the Seating Unit".
Rotating and mounting the seating unit
If the seat is rotated before mounting, the tilt-limiting mechanism then has to be adjusted for safety reasons. See
the section "Assembly: Mounting the Seating Unit" and the two sections that follow.

6.2.2 Rotating the seating unit

CAUTION
Non-activated tilt-limiting mechanism
Falling out of the user due to user error
► Before rotating the seating unit, always adjust the tilt-limiting mechanism.
The seating unit can be mounted onto the mobility base in two directions (facing forward or backward) (see Fig. 9,
see Fig. 10).
To remount the seating unit after rotating it 180°, the tilt limit must be adjusted (see the following section).
9

6.2.3 Adjusting the tilt-limiting mechanism after rotating the seat

Adjusting the tilt-limiting mechanism after rotating the seat is described in the mobility base instructions for use.

6.2.4 Adjusting the back angle

CAUTION
Change in centre of gravity following back angle adjustment
Falling over, falling out of the user due to adjustment errors
► After each modification of the back angle, check the tilt stability. To do so, hold the product with both hands
by the push handle/push bar.
The backrest can be adjusted as needed in a range from 90° to 180°:
1) Twist the lower knob counterclockwise to release the back angle adjustment (see Fig. 11).
Kimba Neo
10
Use
Ottobock | 11