Adjusting The Height Of The Push Handles; Drive Wheels - Otto Bock Invader 480S26 10000 K Instructions For Use Manual

Use
2) Fold the push handle down by 90° (see fig. 44).
CAUTION! Make sure the fingers are not pinched between the push handle and back support.
Unfolding the push handles
1) Fold the push handle up by 90° (see fig. 44).
2) When the active pushing position is reached, you can hear the push handle engage.
43

9.7.2 Adjusting the height of the push handles

The height of the telescoping push handles can be adjusted in order to make pushing easier for the attendant.
1) Release the clamping lever.
2) Adjust the height of the push handle.
3) Close the clamping lever tightly.
INFORMATION: Both push handles must be adjusted to the same height.
45

9.8 Drive wheels

WARNING
Improper assembly of removable wheels
Tipping, falling over of the user due to wheels coming off
► After each assembly, verify the proper fit of the removable wheels. The quick-release axles must be firmly
locked in the wheel attachment.
WARNING
Defective tyres
Accidents/falling due to poor traction, reduced braking force or lack of manoeuvrability
► Maintain sufficient tyre pressure. Note the information in the section "Technical data" or on the tyre sidewall.
► Ensure that the pressure is the same in both tyres.
► Ensure that the tyres have sufficient tread depth.
28
44
Invader 480S26=10000_K