Adjusting The Anti-Tipper - Otto Bock Invader 480S26 10000 K Instructions For Use Manual

25

7.8 Adjusting the anti-tipper

CAUTION
Incorrect installation of the anti-tipper
Tipping over, falling of the user due to incorrect adjustment
► Verify that the anti-tipper has been installed and adjusted properly. Find the appropriate position with the
assistance of a helper.
INFORMATION
In order to adjust the anti-tipper correctly, it may be necessary to combine the steps to adjust the length and
angle.
Adjusting the Length of the Pivot Arm
1) Remove the Allen head screw on the pivot arm (see fig. 26, item 1).
2) Adjust the length of the pivot arm.
3) Bolt down the pivot arm. The outer edge of the anti-tipper roller has to project beyond the largest diameter of
the rear wheels (see fig. 59).
Adjusting the Angle of the Pivot Arm
1) Remove the Allen head screw between the anti-tipper tube and the angle adjuster (see fig. 27, item 1).
2) Loosen the second Allen head screw on the angle adjuster (see fig. 27, item 2).
3) Set the angle of the pivot arm.
4) Bolt down the pivot arm. The max. distance between the anti-tipper rollers and floor is 50 mm (see fig. 59).
26
Invader 480S26=10000_K
Settings and assembly instructions
27
21