Table of Contents
Advertisement
10
12
7.5.2 Adjusting the scissor wheel locks
1) Loosen the Allen head screws in the clamp brackets (see fig. 14, item 1).
2) Adjust/move the support for the scissor wheel lock to any position in the clamp bracket (see fig. 14, item 2).
If necessary: Slide and twist the clamp bracket on the seat tube.
3) Install the scissor wheel lock so that the full braking force is reached and the swivelling parts can also move
freely without colliding.
→ The scissor wheel lock must not hit the frame when it is open (see fig. 15).
→ It must be impossible to push the wheelchair with the wheel locks engaged.
4) Re-tighten the Allen head screws to 15 Nm (see fig. 14).
→ After adjustment, the left and right scissor wheel locks must both have the same braking force.
14
Invader 480S26=10000_K
Settings and assembly instructions
11
13
15
5 mm
17
Advertisement
Table of Contents
