Adjusting The Back Support Upholstery / Seat Upholstery; Adjusting The Back Support Upholstery; Adjusting The Seat Upholstery - Otto Bock Invader 480S26 10000 K Instructions For Use Manual

Table of Contents

Advertisement

Settings and assembly instructions

7.6 Adjusting the back support upholstery / seat upholstery

7.6.1 Adjusting the back support upholstery

INFORMATION
A well-adjusted backrest provides lasting comfort for the wheelchair user and reduces the risk of secondary dam­
age and pressure zones. Do not create too much pressure.
INFORMATION
Ensure that the user's pelvis is positioned as far back in the wheelchair as possible, i.e. between the backrest
tubes.
The back upholstery is attached to the frame tubes with hook-and-loop straps.
1) Fold up the backrest padding.
2) Open and loosen the hook-and-loop straps one after the other (see fig. 16).
3) Sit and position the user in the wheelchair.
4) From the bottom to the top, adjust the tension of the hook-and-loop straps to the weight and anatomical condi­
tion of the user and fasten the straps (see fig. 17).
INFORMATION: The two ends of the hook-and-loop strap have to overlap by at least 100 mm in each
case.
INFORMATION: Adjust the respective lower hook-and-loop straps somewhat tighter.
INFORMATION: Deviating adjustments may be required in specific cases; this is the responsibility of
the attending therapist.
16

7.6.2 Adjusting the seat upholstery

The seat upholstery usually does not need to be adjusted during the initial fitting. However, the tension can be
changed.
The seat upholstery is attached to the frame tubes with hook-and-loop straps.
Invader, Invader Heavy Duty
1) If necessary: Place the seat cushion on the seat upholstery.
2) Open and loosen the rear hook-and-loop straps. Attach a hook-and-loop strap from the middle diagonally over
the straps to secure them (see fig. 18).
3) Sit and position the user in the wheelchair.
4) Adjust the tension of the hook-and-loop straps to the weight and anatomical condition of the user, and fasten
them one after the other (see fig. 19).
INFORMATION: The two ends of the hook-and-loop strap have to overlap by at least 100 mm in each
case.
INFORMATION: Keep the respective front hook-and-loop straps tight.
INFORMATION: Deviating adjustments may be required in specific cases; this is the responsibility of
the attending therapist.
18
17
Invader 480S26=10000_K

Advertisement

Table of Contents
loading

Table of Contents