Adjusting The Support Angle - Otto Bock Invader 480S26 10000 K Instructions For Use Manual

Settings and assembly instructions
22
Version with seat clamp (Invader Wave only)
1) Slightly loosen the Allen head screws on the seat clamps (see fig. 24, item 1).
2) Adjust the lower leg length (continuously adjustable). Ensure that the foot plate bar is inserted into the frame
tube by at least 40 mm.
INFORMATION: A mark on the tube of the leg support indicates the minimum distance the tube must
be inserted during installation.
3) Before final attachment, align the leg support to exactly the same height on the left and right:
→ For example, create a reference plane under the leg support on the left side with the help of a try square
(not illustrated).
→ Measure the distance between the reference plane (below) and the seat clamp (above) exactly.
→ Align the height of the leg support on the right side with millimetre accuracy as well.
4) Tighten the Allen head screws on the seat clamps to 7 Nm.
24

7.7.2 Adjusting the support angle

The leg support angle setting should be chosen so that the ankle is in a relaxed, comfortable position.
Open tube foot support
The support angle cannot be changed.
"Angle-adjustable" leg support
1) Loosen the Allen head screws on the clamp bracket (see fig. 25, item 1).
2) Turn the foot plate to the desired angle (see fig. 25, item 2).
3) Tighten the Allen head screws to 10 Nm.
20
23
Invader 480S26=10000_K