Preparing The Product For Use; Information On Fabrication Of A Prosthesis; Manufacturing The Bench Alignment - Otto Bock Dynion 3R85 Instructions For Use Manual

7 Preparing the product for use

7.1 Information on fabrication of a prosthesis

CAUTION
Incorrect alignment, assembly or adjustment
Injury due to incorrectly installed or adjusted as well as damaged prosthetic components
Observe the alignment, assembly and adjustment instructions.
►
CAUTION
Initial use of the prosthesis by the patient
Fall due to lack of patient experience, incorrect alignment or incorrect adjustment of the pros­
thesis
► For the safety of the patient, use a suitable device (e.g. parallel bars, handrail, wheeled
walker) during initial standing and walking.

7.2 Manufacturing the bench alignment

7 8
+ : CAUTION! To enable the patient to stand safely, align the prosthesis using the
►
alignment images as well as the instructions for use of all prosthetic components used.
► During activation and deactivation of the lock, push the prosthetic knee joint against the exten­
sion stop.
► Perform the bench alignment of the prosthesis with the prosthetic knee joint locked.
► INFORMATION: The posterior section of the prosthetic knee joint can be used as a flexion
stop for the prosthetic socket.
NOTICE! Design the prosthetic socket so that nothing made of metal presses against the pos­
terior section of the prosthetic knee joint.
7
30 mm
50% 50%
50% 50%
14
20 mm
a
0 mm
0 mm
30 mm
50% 50%
a + 5 mm