Mgx 8850 Caveats - Cisco MGX 8850 PXM45 Release Notes

Table 26
DDTs Issue
CSCdy01984
CSCdy06336
CSCdy06940
CSCdy06992
CSCdy07362
CSCdy07500
CSCdy07862
CSCdy07936
CSCdy13924
CSCdy16981
CSCdy20771
CSCdy25348
CSCdy26633
CSCdy28633
CSCdy28674
CSCdy29758
CSCdy37455
CSCdy41151
CSCdy48320
CSCdy56990
CSCdy65628
CSCdy67350

MGX 8850 Caveats

Severity level 1, 2, and 3 caveats are organized in this section as follows:
•
•
•
MGX 8850 Open Caveats in Release 3.0.10
Table 27
OL-2914-01 Rev D0, July 3, 2003
Resolved Caveats for MGX 8830 3.0.10 Software (continued)
Description
tstdelay causes cell loss on CESM.
Need enhancement in resecd command.
Need mechanism to resynch port status between PXM.
clean up errors logged by pcema if get next on ifT
unable to up connection after downed .
Stdby pxm in slot 7 stuck in empty state .
cannot change abr-std shaper (pcr,mcr,icr) paramet.
upon installation of nw stdby pxm card stuck in in.
Modification of fr-atm fails on PXM1E.
xcnfchanstdabr & xcnfchan on FRSM-T1 caused failed.
unable to add redundancy for slot 22.
Number of NCDP messages showing up in log
Need mechanism to resynch port status between PXM.
after issuing xcnfconstdabr asum card is freezing.
removing and inserting back card does not cause st.
Standby PXM1E reset while syncing with the primary.
TB Hard2: memLeak in ipc buffer id 0x10003 (unique.
Failure to make AAL2 SVC Calls after PXM1E SWOVE
switchredcd on slot 1 caused slot 1 to be stuck in boot stat
TB+ Hard2:mem alloc. failure in buffer 0x10003 after upgr
line 2.5 went to LOF after switchcc.
clk signals not available after APS switch
"MGX 8850 Open Caveats in Release 3.0.10"
"Status of MGX 8850 Caveats Found in Previous Releases"
"MGX 8850 Resolved Caveats in Release 3.0.10"
lists the Severity 1 open caveats for the MGX 8850 Release 3.0.10 software.
Release Notes for Cisco MGX 8850 (PXM45), MGX 8850 (PXM1E), and MGX 8830, Software Release 3.0.10
Caveats
69