Leds - Cisco Catalyst 9300X Hardware Installation Manual

LEDs

Network Module
C9300-NM-8X
C9300-NM-2Y
C9300-NM-BLANK
C9300X Network Modules
Note
C9300X-NM-2C
C9300X-NM-4C
C9300X-NM-8M
C9300X-NM-8Y
C9300X-NM-BLANK
Note
For information about the network modules, see the
For cable specifications, see
LEDs
You can use the switch LEDs to monitor switch activity and its performance.
Figure 8: Switch Front Panel LEDs
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
14
1
Description
This module has eight 10 GE slots with an SFP+ port in each slot. Each port
supports a 1 GE or 10 GE connection.
Any combination of SFP and SFP+ modules are supported.
This module has two 25 GE SFP28 module slots.
Any combination of SFP, SFP+ and SFP28 modules are supported.
Insert this blank module when the switch has no uplink ports (this is required for
sufficient air flow).
1
Note that C9300X network modules are supported only on C9300X switches.
This module has two 40 GE/100 GE slots with a QSFP+ connector in each slot.
This module has four 40 GE/100 GE slots with a QSFP+ connector in each slot.
This module is supported only on C9300X-24Y.
This module has eight Multigigabit (mGig) module slots.
This module has eight 25 GE/10 GE/1 GE slots with an SFP28 port in each slot.
Insert this blank module when the switch has no uplink ports (this is required for
sufficient air flow).
1. All network modules are hot-swappable.
Cables and Adapters, on page
Installing a Network Module in the Switch, on page
123.
Product Overview
68.