Connecting To 1000Base-T Sfp Modules - Cisco Catalyst 3750 Hardware Installation Manual

Connecting to an SFP Module

Connecting to 1000BASE-T SFP Modules

Caution
Step 1
Note
Figure 3-47 Connecting to an SFP Module Port
1 3
1 4
1 5
1 6
1 7
1 8
1 9
13 X
2 0
2 1
14 X
1
1
RJ-45 connector
Step 2
Step 3
Catalyst 3750 Switch Hardware Installation Guide
3-58
Follow these steps to connect a Category 5 cable to a 1000BASE-T SFP module:
To prevent ESD damage, follow your normal board and component handling
procedures.
When connecting to servers, workstations, and routers, insert a four twisted-pair,
straight-through cable in the RJ-45 connector. When connecting to switches or
repeaters, insert a four twisted-pair, crossover cable.
When connecting to a 1000BASE-T device, be sure to use a four twisted-pair,
Category 5 cable.
2 2
C a t a ly s t
2 3
2 4
3 7 5 0
S E R IE S
23 X
1
24 X
Insert the other cable end in an RJ-45 connector on a target device.
Observe the port status LED.
The LED turns green when the switch and the target device have an established
link.
2
Chapter 3 Switch Installation
78-15136-03