Advertisement
5.9
Connecting Balloon Controller
[Note] This endoscope cannot be connected to the balloon controller PB-10.
5.9.1
Connecting Balloon Controller
(1) Install the balloon controller referring to the operation
manual of the balloon controller.
Connect the tube kit as follows.
Balloon controller
Tube connector 2
(endoscope side)
Tube connector 1
(Over-tube side)
(2) Securely insert the endoscope-side connector of the
tube kit (TY-06S) into the balloon air feed inlet of the
endoscope.
Connect the endoscope and the Over-tube to the balloon controller
properly. Before insertion, make sure that the balloon operates as
intended.
Otherwise, it may cause an injury.
Applicable tube
Attached tube kit
TY-06S
Tube 1 (white tube) of
tube kit TY-04
Chapter 5 Preparation for Use of Endoscope
CAUTION
5-25
Advertisement
Chapters
