Advertisement
(9) Slide the fixing rubber down from the mounting fixture
(ST-01B) to the end of the balloon on the curved section
side.
When using a hood, attach a hood by following the
procedure described in "5.7.3 Attaching Hood."
"5.7.3 Attaching Hood"
<When a hood is not used>
(10) Slide the fixing rubber to the end of the balloon as in step
(9).
[Note]
Carefully attach the fixing rubber so as not to cover the
balloon air feed outlet.
Chapter 5 Preparation for Use of Endoscope
5-21
Advertisement
Chapters
