Field Settings for Outdoor Unit
2.3
Settings by BS Buttons
The following settings can be made using the BS buttons on the PCB.
In case of a multi outdoor system, make these settings with the master outdoor unit (settings
made with a slave unit are disabled).
BS buttons
MODE
Used to make
setting mode
changes.
Normal mode:
Setting mode: Used to make changes to operating status, performance settings or address
Monitor mode: Used to verify contents of settings, quantity of units, current value of some
Mode changing procedure can be selected using the MODE (BS1) button as shown
132
BS1
BS2
BS3
SET
RETURN
(TEST)
(RESET)
Used to make
field settings.
Blank: If no abnormality is detected and initialization of communication was completed.
Flashing combination of letter and number (4 digits): Error code detected by outdoor
control or trouble by communication.
setting.
parameters during operation of outdoor unit.
below:
Press and hold the
MODE (BS1) button
for 5 seconds or more
Setting mode
Press the MODE
SEG1 SEG2 SEG3
(BS1) button once
7 segment display (SEG1-3)
Normal mode
Setting mode
Monitor mode
Press the MODE
(BS1) button once
Normal mode
SEG1 SEG2 SEG3
Part 5 Field Settings and Test Operation
SiAF341904E
SEG1 SEG2 SEG3
Monitor mode
SEG1 SEG2 SEG3