Daikin RXQ12AHR Service Manual page 122

Field Settings for Indoor Unit
1.4.4 Time for Absence Area Detection
(For units with the infrared presence sensor only)
By selecting the energy-saving operation mode in the absence, the target temperature is shifted
to the energy-saving end by 1°C (maximum 2°C) after the state of absence continues for a
certain period of time.
Absent time defined for detection can be selected as follows:
10 (20)
 The set temperature displayed on the remote controller remains the same even if the target
 As soon as people are detected while the temperature is shifted, this control will be
1.4.5 Dry Operation Time during Eco Mode
 If you switch the operation mode to "Dry" while the eco mode is enabled, the mode will
If you want to increase the duration of dry operation, change the Second code No. as indicated
in the following table.
Note 1) Increasing duration of dry operation degrades the energy efficiency
10 (20)
Note 2) When group control is enabled, all indoor units in the same group have a same set value for
duration of dry operation.
1.4.6 Low Airflow Setting when Thermostat OFF during Eco Mode
This setting changes the airflow volume to LL in coordination with the eco mode when cooling thermostat
OFF is set. Also, the airflow direction is changed to horizontal.
When disabled:
When enabled: LL when Te ≥ 7°C
10 (20)
116
Mode First Second
No. Code No. Code No.
01
7
02
temperature is shifted.
cancelled (reset).
automatically switch to "Cooling" after a certain period of time is elapsed.
Mode First Second
No. Code No. Code No.
01
02
10
03
04
12 (22)-6 (the airflow volume setting when cooling thermostat OFF is enabled)
13 (23)-7 (the swing setting when cooling thermostat OFF is enabled) is as set
Mode First Second
No. Code No. Code No.
01
11
02
State of absence
31
30
29
28
27
Cooling (at 28°C)
26
30 (60)∗ 60 (120)∗
Elapsed time of absence (minutes)
∗ The values in parentheses represent the time
when Second code No. is 02.
Continuous (not returning to cooling)
: Factory setting
Contents
30 minutes
60 minutes
Human detection
: Factory setting
Contents
30 minutes
60 minutes
90 minutes
: Factory setting
Contents
Disabled
Enabled
Part 5 Field Settings and Test Operation
SiAF341904E