Husqvarna FC 350 2014 Repair Manual page 33

6
FORK, TRIPLE CLAMP
m
/
-
Place the special tool onto the piston rod.
I
Mounting sleeve (T14029) (r p. 232)
-
Grease seal ring @ and slide onto the piston rod with the open side forward.
Remove the special tool.
I
Lubricant (T511) (r p. 219)
-
Slide screw sleeve
-
Press the seal ring flush into the screw sleeve.
-
Grease the O-ring of the screw sleeve.
I
Lubricant (T158) (r p. 219)
-
Tighten the screw sleeve.
Guideline
Screw sleeve on the car­
tridge
200883-10
-
Mount filling screw
-
Clamp the cartridge vertically and fill with fork oil to the lower edge
upper part of the cartridge.
I
Fork oil (SAE 4) (48601166S1) (r p. 218)
✓ The piston rod is fully extended.
-
Mount the screw cap with the membrane holder and tighten with the special tool.
I Guideline
Screw cap on the cartridge
I
Pin wrench (T103) (r p. 228)
-
Bleed and fill the cartridge. (r p. 35)
-
Fill the cartridge with nitrogen. (r p. 36)
-
Mount adjusting tube Gi).
48
-
Screw nut
Info
�
The nut must be screwed tightly against the stop. Do not use a tool.
200835-11
fD
onto the piston rod.
M24x1
@)
with the O-ring.
I
M41x1
all the way on with the collar facing forward.
40 Nm Loctite ® 241
(29.5 lbf ft)
6)
of the
I
30 Nm (22.1 lbf ft)
31
I