Positioning The Fork Protection; Removing The Fork Legs; Installing The Fork Legs - Husqvarna FC 350 2014 Repair Manual

6
FORK, TRIPLE CLAMP
6. 7 Removin the fork le s
lnstallin
-
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
I
Remaining screws, chassis
-
Position the brake line and clamp. Mount and tighten screws
-
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
I
Remaining screws, chassis
Preparatory work
-
Raise the motorcycle with the lift stand. (or p. 10)
-
Remove the front wheel. (or p. 92)
Main work
O
-
Remove screws and take off the clamp.
8
-
Remove screws and take off the brake caliper.
-
Allow the brake caliper and brake line to hang tension-free to the side.
Info
Do not pull the hand brake lever if the front wheel has been removed.
@).
-
Loosen screws Take out the left fork leg.
C,.
-
Unscrew screws Take out the right fork leg.
Main work
-
Position the fork legs.
O
✓ Bleeder screws
• Info
I
Grooves are milled into the side of the upper end of the fork legs. The sec­
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
8.
-
Tighten screws
Guideline
I
Screw, top triple clamp
@).
-
Tighten screws
Guideline
I
Screw, bottom triple clamp
I
M6
face forward.
14
O.
110 Nm (7.4 lbf ft)
8.
10 Nm (7.4 lbf ft)
17 Nm (12.5 lbf ft)
12 Nm (8.9 lbf ft)