Checking The Chain, Rear Sprocket, Engine Sprocket, And Chain Guide - Husqvarna FC 350 2014 Repair Manual

WHEELS
14

Checking the chain, rear sprocket, engine sprocket, and chain guide

14.6.7
..
l
o o o--�--0 o
2 3
16 17 18
Info
The wide adjustment range of the chain adjusters (32 mm (1 .18 in))
enables different secondary ratios with the same chain length.
Chain adjusters
Finishing work
-
Remove the motorcycle from the lift stand. (..- p. 10)
Preparatory work
-
Raise the motorcycle with the lift stand. (..- p. 10)
Main work
-
Shift gear to neutral.
-
Check the rear sprocket and engine sprocket for wear.
If the rear sprocket or engine sprocket are worn:
-
Change the drivetrain kit. (..- p. 1 01)
•
I
400227-01
-
Pull at the top part of the chain with the specified weight 6).
Guideline
I
Weight, chain wear measurement
-
Measure distance
• Info
I
Chains do not always wear evenly, which is why the measurement should
be repeated at several locations on the chain.
Maximum distance
part of the chain
If the distance
-
Change the drivetrain kit. (..- p. 1 01)
!
•
I
o
400987-10
-
Check the chain sliding guard for wear.
If the lower edge of the chain pin is at the level of or below the chain sliding
guard:
-
Change the chain sliding guard.
-
Check that the chain sliding guard is firmly seated.
If the chain sliding guard is loose:
-
Tighten the chain sliding guard.
Guideline
Screw, chain sliding
guard
C,
can be turned by 180
Info
The engine sprocket, rear sprocket, and chain should only be
replaced together.
110 ... 15 kg (22 ... 33 lb.)
CD
of 18 chain rollers on the lower chain section.
CD
272 mm (1 0. 71 in)
on the longest
CD
is larger than the specified length:
Info
When a new chain is mounted, the rear sprocket and engine
sprocket should be changed as well.
New chains wear more rapidly on old, worn rear sprockets and
engine sprockets.
M6
° .
6Nm Loctite 243
®
(4.4 lbf ft)
99
™