Checking The Electric Starter Drive - Husqvarna FE 250 2016 Repair Manual

18 ENGINE
18.4.31
Check the gear mesh and bearing of starter idler gear
Check the gear mesh and bearing of torque limiter
Check the gear mesh and bearing of freewheel gear
Check freewheel
Check the gear mesh of starter motor
Change O-ring
Connect the negative cable of a 12 volt power supply to the housing of the starter motor. Connect the posi­
tive cable of the power supply briefly with the connector of the starter motor.
198

Checking the electric starter drive

If there is damage or wear:
-
Change the starter idler gear.
If there is damage or wear:
-
Change the torque limiter.
If there is damage or wear:
-
Change the freewheel gear or bearing.
C,
for damage and wear.
If there is damage or wear:
-
Change the free wheel.
If there is damage or wear:
-
Change the starter motor.
C)
of the starter motor.
If the starter motor does not turn when the circuit is closed:
-
Change the starter motor.
·-8
0
0
O
for damage and wear.
8
for damage and wear.
8
for damage and wear.
0
for damage and wear.
305006-10
•