Checking The Chain, Rear Sprocket, Engine Sprocket And Chain Guide - Husqvarna FE 250 2016 Repair Manual

14 WHEELS
14.8.6
118

Checking the chain, rear sprocket, engine sprocket and chain guide

..
400227-01
Main work
- O.
Loosen nut
- 8.
Loosen nuts
-
Adjust the chain tension by turning adjusting screws (D left
and right.
Guideline
Chain tension
Turn adjusting screws (D on the left and right so that the
markings on the left and right chain adjusters are in the
same position relative to reference marks f). The rear
wheel is then correctly aligned.
8-
-
Tighten nuts
-
Make sure that the chain adjusters
the adjusting screws (D.
0-
-
Tighten nut
Guideline
Info
The wide adjustment range of the chain adjusters
(32 mm (1.26 in)) enables different secondary ratios
with the same chain length.
8
Chain adjusters
Finishing work
- Remove the motorcycle from the lift stand.
Preparatory work
- Raise the motorcycle with a lift stand.
Main work
- Shift gear to neutral.
- Check the rear sprocket and engine sprocket for wear.
If the rear sprocket or engine sprocket is worn:
- Change the drivetrain kit.
Info
The engine sprocket, rear sprocket and chain
should always be replaced together.
55 ... 58 mm (2.17 ...
1
2.28 in)
8
are fitted correctly on
M20x1.5 80 Nm (59 lbf ft)
can be turned by 180 .
°
(� p. 12)
(� p. 12)
(!ill p. 121)