Husqvarna FE 250 2016 Repair Manual page 148

16 BRAKE SYSTEM
146
-
Cover the painted parts.
O
-
Remove screw cap with membrane and the O-ring.
-
Draw the old brake fluid out of the brake fluid reservoir using
a syringe and fill with fresh brake fluid.
Syringe (50329050000)
Brake fluid DOT 4 (� p. 314)
8.
-
Mount bleeder cover
I Bleeder cover (00029013006)
-
Connect the bleeding device.
I Bleeding device (00029013100)
-
Open shut-off valve (s).
• Info
I
Follow the operating instructions of the bleeding
device.
-
Ensure that the filling pressure is correctly set at pressure
gauge 6). If necessary, adjust the filling pressure at pressure
regulator Ci).
Guideline
I Filling pressure
8
-
Pull off protection cap
hose of the bleeder bottle.
I Bleeding device (00029013100)
0
Open bleeder screw
• Info
I
Bleed until new brake fluid emerges from the bleeder
bottle hose without bubbles.
-
Tighten the bleeder screw.
-
Close shut-off valve (s).
-
Open the bleeder screw again until no more brake fluid
emerges.
• Info
I
This prevents overfilling of the brake fluid reservoir.
-
Tighten the bleeder screw. Remove the hose of the bleeder
bottle. Mount the protection cap.
-
Disconnect the bleeding device. Remove the bleeder cover.
(� p. 320)
(� p. 318)
(� p. 318)
I 2 ... 2.5 bar (29 ... 36 psi)
of the bleeder screw. Connect the
(� p. 318)
by approx. one-half turn.