Husqvarna FE 250 2016 Repair Manual page 42

6 FORK, TRIPLE CLAMP
40
-
Press the new bearing ring up to the stop with special
tool@).
Tool bracket (58429089000)
Pressing tool (58429091000)
-
Remove upper bearing ring
Tool bracket (58429089000)
Pressing tool (58429092000)
-
Press the new bearing ring up to the stop with special
tool@).
Tool bracket (58429089000)
Pressing tool (58429091000)
-
Remove lower steering head bearing@).
-
Remove the seal ring.
-
Grease and mount the new seal ring.
-
Press on the new bearing with a suitable tube as far as it will
go.
D00075-10
Finishing work
-
Install the lower triple clamp.
-
Install front fender.
-
Install the front wheel.
-
Install the headlight mask with the headlight.
-
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
-
Check the play of the steering head bearing.
-
Remove the motorcycle from the lift stand.
-
Check the headlight setting.
(a p. 321)
(0 p. 321)
C,
with special tool@.
(ll!l p. 321)
(ll!l p. 322)
(a p. 321)
(ll!l p. 321)
(ll!l p. 36)
(ll!l p. 103)
(0 p. 112)
(0
(0
(a p. 12)
(a p. 151)
p. 105)
p. 38)