Changing The Engine Oil And Oil Filter, Cleaning The Oil Screen - Husqvarna FE 250 2016 Repair Manual

Changing the engine oil and oil filter, cleaning the oil screen

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
-
Wear suitable protective clothing and safety gloves.
-
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Drain the engine oil only when the engine is warm.
21
Info
After switching off the engine, wait one minute
before checking the level.
The engine oil is at a level between lower edge
middle @ of the level viewer.
If the engine oil is not at a level between lower
G
edge and middle @ of the level viewer:
-
Add engine oil.
Preparatory work
-
Park the motorcycle on a level surface.
-
Remove the engine guard.
Main work
-
Place a suitable container under the engine.
O
-
Remove oil drain plug
Info
Do not remove screws
8
-
Remove screw plug
Completely drain the engine oil.
-
Thoroughly clean the parts and sealing surfaces.
LUBRICATION SYSTEM
G
(i!!ll p. 241)
(� p. 45)
with the magnet and seal ring.
G
on both sides.
@)
with oil screen and the O-rings.
and
239