Table of Contents
Advertisement
21
LUBRICATION SYSTEM
240
(D
-
Position oil screen
with the O-rings on a pin wrench.
-
Position the pin wrench through the drilled hole of the screw
plug in the opposite section of the engine case.
Push the oil screen all the way into the engine case.
-
Mount and tighten screw plug
Guideline
Screw plug, oil
screen
-
Mount and tighten oil drain plug
new seal ring.
Guideline
Oil drain plug with
magnet
C,.
-
Remove screws
Remove the oil filter cover with the O
ring.
0
-
Pull oil filter
out of the oil filter housing.
I Lock ring plier (51012011000)
-
Completely drain the engine oil.
-
Thoroughly clean the parts and sealing area.
-
Lay the motorcycle on its side and fill the oil filter housing to
about ½ full with engine oil.
-
Fill the oil filter with engine oil and place it in the oil filter
housing.
Lubricate the O-ring of the oil filter cover and mount it with
the oil filter cover (D.
-
Mount and tighten the screws.
Guideline
I
I
Screw, oil filter cover
-
Stand the motorcycle upright.
8
with the O-ring.
M20x1.5
15 Nm (11.1 lbf ft)
O
with the magnet and a
M12x1.5
20 Nm (14.8 lbf ft)
(!!;!I
p. 320)
110 Nm (7.4 lbf ft)
M6
Advertisement
Table of Contents
