Husqvarna FE 250 2016 Repair Manual page 121

l
o
o o--�--0 o
16 17 18
2 3
-
Pull on the upper part of the chain with the specified
weight f).
Guideline
Weight of chain wear mea­
surement
-
Measure the distance ti) of 18 chain links in the lower chain
section.
Info
Chain wear is not always even, so you should repeat
this measurement at different chain positions.
Maximum distance ti) at
the longest chain section
l
If the distance ti) is greater than the specified measure­
o
ment:
-
Change the drivetrain kit.
400987-10
•
I
-
Check the chain sliding guard for wear.
If the bottom edge of the chain bolt is in line with or below
the chain sliding guard:
-
Change the chain sliding guard.
-
Check that the chain sliding guard is firmly seated.
If the chain sliding guard is loose:
-
Tighten the chain sliding guard.
Guideline
Screw, chain
sliding guard
10 ... 15 kg (22 ... 33 lb.)
272 mm (10. 71 in)
(� p. 121)
Info
When the chain is replaced, the rear sprocket
and engine sprocket should also be changed.
New chains wear out faster on old, worn
sprockets.
M6 6 Nm (4.4 lbf ft)
14 WHEELS
®
Loctite 243
™
119